Articles Blog

iPhone XS battery replacement

iPhone XS battery replacement


Hello everyone, today I show you how to disassemble
iPhone XS and replace the battery To disassemble the iPhone XS you need the
following tools: • Screwdriver set
• Tweezers • Opening plastic tool
• Plastic mediator • Suction cup for removing display
In the description of this video, I left links to the necessary tools and parts for replacement. Before disassembling, turn off the iPhone
and remove the sim card tray. Unscrew two screws near the lightning port. Using a hairdryer, heat the surface of the
display for a one minute. This will make it easier to separate the display
from the iPhone case. Apply suction cup to the bottom edge of the
display and pull up on the ring. Push the plastic mediator between the display
and iPhone case. Now carefully separate the display from the
iPhone case. Open iPhone by swinging the display to the
right side, like the cover of a book. Next, unscrew the 4 screws on the metal panel
using a Tri-Wing screwdriver and one screw using a PH00 screwdriver. Now you can remove the metal panel. Disconnect the battery cable from the mainboard
and 3 cables of the display. Now you can remove the display. To replace the battery on the iPhone XS, you
need to remove the speaker and the Taptic Engine
Unscrew the 5 screws and remove the antenna module. Remove that screw between the Taptic Engine
and the speaker. Remove the metal bracket and disconnect the
cable. Now carefully peel off the cable from the
speaker. Please note: the speaker glued to the case,
and if you want to save the adhesive tape, which can be reused during assembly, heat
with a hairdryer and carefully peel the speaker from the iPhone case. Now you can remove speaker
Unscrew the 2 screws on the Taptic Engine. Disconnect the cable and now you can remove
the Taptic Engine from the iPhone case. Take the tweezers and peel off the edge of
adhesive tape from the battery. Slowly pull on the adhesive tape away from
the battery. In the same order, remove the remaining 3
tapes from under the battery. Now you can remove the battery from the iPhone
case. In the description under the video, I left
a link where you can buy new battery for iPhone XS
The new battery you should glue in a specially designated place on the surface of iPhone
XS case. Set Taptic Engine into the case and connect
the cable. Next, fasten 2 screws to the Taptic Engine. Set the speaker into the case. Connect cable between the Taptic Engine and
the speaker, then set the metal bracket and fasten screw on top. Install the antenna module and fasten 5 screws. Now you can install the display and test how
phone works before final assembly with gluing the iPhone case. Connect 3 cables from the display module to
the mainboard and only after that connect the battery cable. Turn on the iPhone and let’s check how everything
works. If the phone works well, the next step is
final assembly with gluing. Remove the old adhesive tape from the iPhone
case. Using medicine alcohol, wipe the surface of
the iPhone housing where old tape was located. Now, take new adhesive tape and apply to the
case. With this tape, you save waterproof resistance
of your iPhone. I left link in description where you can buy
this adhesive tape. Connect 3 cables from the display to mainboard
and only after that connect battery cable to the mainboard. Set metal panel and fasten 5 screws. Turn over the display and press down the display
around the perimeter of surface. Fasten two screws near the lightning port. Now you can turn on the iPhone and use it.

1 thought on “iPhone XS battery replacement”

Leave a Reply

Your email address will not be published. Required fields are marked *