Articles Blog

iPhone XS screen replacement

iPhone XS screen replacement


Hello everyone, today I show you how to disassemble
iPhone XS and replace display module To disassemble the iPhone XS you need the
following tools: • Screwdriver set
• Tweezers • Opening plastic tool
• Plastic mediator • Suction cup for removing display
In the description of this video, I left links to the necessary tools and parts for replacement. Before disassembling, turn off the iPhone
xs and remove the sim card tray. Unscrew two screws near the lightning port. Using a hairdryer, heat the surface of the
display for a one minute. This will make it easier to separate the display
from the iPhone case. Apply suction cup to the bottom edge of the
display and pull up on the ring. Push the plastic mediator between the display
and iPhone case. Now carefully separate the display from the
iPhone case. Open iPhone by swinging the display to the
right side, like the cover of a book. Next, unscrew the 4 screws on the metal panel
using a Tri-Wing screwdriver and one screw using a PH00 screwdriver. Now you can remove the metal panel. Disconnect the battery cable from the mainboard
and 3 cables of the display. Now you can remove the display. To replace the display on iPhone XS, you need
to disconnect the speaker with light and proximity sensors from the original display and install
it on a new display module. Unscrew 3 screws using a Tri-Wing screwdriver. Using hairdryers, heat the front side of the
display where located the sensors. Carefully separate the sensors from the display
housing. If this sensor is damage, the Face ID will
be lost, so special care is required not to damage one of these components during removal
and replacement of the display. In the description of this video, I left links
where you can buy new display. Install the proximity sensor and light sensor. Install the speaker and fasten the 3 screws. The display module assembled, now you can
install the display and test how everything works before final assembly with gluing the
iPhone case. Connect 3 cables from the display module to
the mainboard and only after that connect the battery cable. Turn on the iPhone and let’s check how everything
works. If the phone works well, the next step is
final assembly with gluing. Remove the old adhesive tape from the iPhone
case. Using medicine alcohol, wipe the surface of
the iPhone housing where old tape was located. Now, take new adhesive tape and apply to the
case. With this tape, you save waterproof resistance
of your iPhone. I left link in description where you can buy
this adhesive tape. Connect 3 cables from the display to mainboard
and only after that connect battery cable to the mainboard. Set metal panel and fasten 5 screws. Turn over the display and press down the display
around the perimeter of surface. Fasten two screws near the lightning port. Now you can turn on the iPhone xs and use
it.

Leave a Reply

Your email address will not be published. Required fields are marked *